Hole Covers for Hot/Cold Clawfoot Tub Drillings

These hole plugs are intended to cover the existing hot and cold water faucet drilling holes on a bathtub's interior wall.

These are most often used when you have a bathtub with pre-existing holes, but are using a tub faucet that is not mounted to the interior vertical wall of the bathtub (such as a freestanding faucet, or a bathroom wall mounted faucet).

These clawfoot tub hole covers are 2-3/8" in diameter. They are larger than the actual holes they will be covering. This basically means that you can plug hole drillings from a 1" inch diameter (or less), all the way up to 2" inches in diameter, and these will work just fine for you. These hole covers are available in your choice of finishes.

For installation, you place the decorative side with the threaded rod inside the bathtub, through the hole, then screw on the chrome finish backing disc from behind, and tighten.

Finally, your installer would cut off the extra portion of threaded rod that wasn't needed, and then screw on the decorative cap to hide the remaining threads.

The extra long threaded rod ensures that these will work with just about any bathtub.

NOTE: The image shown is pictured with an overflow faceplate cover to show location only. The overflow faceplate cover itself is NOT INCLUDED.


To order a set of these clawfoot bathtub hole covers, simply select the finish you desire below, and click the "Add Item to Cart" button.